hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 180 / 302

www.acornfiresecurity.com
SECTION 5 (cont)
The columns shown above are:
Position: This is the order the devices are learnt on to the associated Fire Control Panel in.
Using the vertical scroll bar on the right hand side, it can be seen that this column
shows a maximum of 32 devices - the maximum number that can be associated
with a Translator Module micro-cell/cluster.
Expander: This column indicates to the engineer if a device is on the Translator Module
(Expander 0) or an Expander Module (1 - 7).
Detector:
Type:
This column indicates the digital address that has been given to a device. As can
be seen from the above example, there may be an instance where the same
number occurs. This will happen if there are Expander Modules on the system.
The previous column should be read in conjunction with this column to determine
the correct digital address for a child device.
This column indicates to the engineer the type of device that should be found at
this address.
Comments : This column and cell will only have information in if the Comments cell in the
"Configuration" tab has been used for the child devices.
It may be that there are gaps in the above table where devices have been removed from the
system. These will appear either as a series of hash marks (###) or as a gap. This can lead to
incorrect identification of devices at the Fire Control Panel. To overcome this, on completion of
the LOAD process, the following action may need to be followed. Anywhere in the table, right click
with the mouse.
WCTM Issue 3 Page 93 of 155