hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 150 / 302

www.acornfiresecurity.com
SECTION 5 (cont)
Fig A
Fig B
Fig C
On completion of parameter/process changing press
Un-checking the "LED Indication" box -
"Battery discharge" - will stop the
device LED indicating if the batteries
reach a discharge state. The default for
this indication is to remain checked and it
is recommended that this indication be
left in the default state.
The "Period of control signals
transmission" should be left at the
default value of 7 seconds. If the device
quantity is > 1, only the first device
address will appear in the parameter
window but all devices of the type
selected will have the same operational
parameters.
The "Supervision period" would
normally be left unchanged. This can be
changed from the default "3 mins" by
changing the level in the "Supervision
period" window.
The "External fault input" is, by default
checked. This will monitor a fault from an
external source. In this application this
process is not used and should be left
disabled. (see Fig. A)
The relay output of the Module can be
changed to one of four variants
depending on the site application. This is
altered by changing the parameter in the
"Relay output" window (see Fig A)
There is a stand-alone voltage output
providing the installer with an option of
12V or 24V. The required output can be
chosen by selecting 12V or 24V at the
window shown in Fig. B. The output can
be selected as a constant or switching
output by changing the parameter as
indicated in Fig. C
.
The window will close and the user will be directed back to the "Configuration" tab for adding
further devices (if required).
WCTM Issue 3 Page 78 of 155