hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 67 / 302

www.acornfiresecurity.com
SECTION 3 (CONT)
The Start Address will be assigned to the Translator Module. All field devices will be assigned to
contiguous addresses.
e.g. 1 Translator 2 Manual Call Points on Fire Detection Loop 1 with Translator Module start
address = 110.
Translator Address Address Seen at Control Panel
Translator Module address 110 110
Manual Call Point 1 address 111 111
Manual Call Point 2 address 112 112
WIRELESS FIELD DEVICE PROGRAMMING
(NOTE:- Prior to commencing any device programming, ensure the Primary (CR123A) and Secondary
(CR2032) power cells are available. The secondary cell is fitted to the device with the positive (+) side
upper most. This must be fitted prior to any programming, and must be fitted with the switch in the 1
position. The secondary cell in a wireless Wall Sounder is the same as the primary cell).
On the wireless device being programmed set the jumper into the ON position before proceeding any
further.
To add a device, use the P3/P4 keys and scroll up/down until is displayed. Confirm using the P2
key. Use P3/P4 key to select the appropriate menu:
( for Detectors, for input devices, for output devices)
Use P3/P4 key to select Add. Confirm using the P2 key.
The display will show the "link" ( ) indication and LED DL4 will turn on. Insert Primary battery
and wait until the RF device LED indicator has blinked RED 4 times (to indicate the device has
entered programming mode).
Switch the RF device jumper from ON to the 1 position. The RF device LED will flash GREEN
(showing that initial programming is completed), which is followed by the LED blinking RED for a short
period of time. The device will then flash GREEN two more times before extinguishing. (Note: if the
device is not put back in to its base/backbox, a fault indication will appear on the Translator Module
LCD display).
The Translator Module LCD will display the address assigned to the device and DL4 LED will turn off.
Programming for that device is now complete.
Press P1 push-button to return to the device menu.
On completion of programming all field devices on to the Translator Module, the Translator Module
and field devices can now be added on to the associated Fire Control Panel as if they were normal
hardwired devices. The devices can be learnt on to the Fire Control Panel using an "Autolearn"
process.
WCTM Issue 3 Page 36 of 155