hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 233 / 302

www.acornfiresecurity.com
SECTION 6 (cont)
At the Translator Module, right click on "TRANSLATOR" selecting "Program TRANSLATOR"
from the drop-down list:
The Translator Module will now complete the final programming sequence required for this
system. On completion of the programming sequence the engineer should now carry out a
LOAD command at the Translator Module, as shown on P.90.
NOTE: During the process detailed above, the Translator Module will display "LOEr" on the
LCD display accompanied by the centre yellow LED flashing. This is normal and no action
should be taken.
It is now possible to view and control child devices on the Expander Module from the computer
EVEN if the installer has the computer connected to the Translator Module - child devices can
be added/deleted, remote control actions carried out, investigation of the Link Quality of the
Expander Module child devices, etc.
To view the Link Quality of the devices on an Expander Module, ensure the "Turn on data
exchange" box is checked under the "Events" tab. Then select the "Link Quality" tab on
the Wirelex software. Right click on "TXLTR" in the Expanders section, highlighting "Sending
signal levels between all expanders" selecting the "Turn on" option when presented. After a
short delay, all the signal levels for the devices on the Expander Modules will start to appear.
WCTM Issue 3 Page 120 of 155