hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 69 / 302

www.acornfiresecurity.com
SECTION 3 (CONT)
TRANSLATOR MODULE INDICATIONS
The following table shows the control panel behaviour according to the events generated by the
Translator:
DL1: blinks when the Translator Module is being polled by the Fire Control Panel.
DL2: indicates a system fault condition. This is to be investigated using the Wirelex software tool
DL3: illuminates constantly to indicate that an RF device has reached a low power level threshold, e.g.
the primary power cell should be replaced - usually accompanied by images 1 or 2 below.
DL4: illuminates when the Translator Module is searching for a radio device.
DL5: illuminates and the device type is displayed on the LCD
DL6: not used
TRANSLATOR LCD DISPLAY INDICATIONS
(Image 1) Primary battery level for device with address 138 is low.
(Image 2) Secondary battery level for device with address 138 is low.
(Image 3) Wait indication. The Translator is performing a time consuming action.
(Image 4) Fatal error. The last action performed has generated an error.
(Image 5) The last action performed has been completed successfully.
(Image 6) An RF device has detected a fire or received a fire activation signal.
(Image 7) The Translator Module is radio linking to a field/child device.
(image 8) This indicates there are no more loop addresses available
(Image 9) When carrying out changes to the system, confirmation of change is
requested.
(Image 10) Spanner icon indicates a fault with a device and is accompanied by
the device number.
WCTM Issue 3 Page 37 of 155