HP StoreAll 8200, Руководство по установке, Страница: 33 / 252

Cabling the HP StoreAll 8800 Storage system
Note the following guidelines when connecting the 8800 to MDL SAS or ENT SAS capacity blocks:
•
Controller 1 contains ports 1 and 2 in slot 1. Together, these ports form a controller pair.
•
Controller 2 contains ports 1 and 2 in slot 4. Together these ports form a controller pair.
The initial connection must be made from controller 1 (port 1 in slot 1) on the StoreAll node.
•
Port 1 of each controller (in slot 1 and slot 4) connects to I/O module A on the capacity block.
•
Port 2 of each controller (in slot 1 and slot 4) connects to I/O module B on the capacity block.
•
Port 1 and port 2 of the same controller (either controller 1 or controller 2) should connect to
different drawers in the MDS SAS capacity block.
•
Each controller pair can support a single MDL SAS capacity block or up to 4 ENT SAS capacity
blocks.
•
When connecting a SAS chain of up to 4 ENT SAS capacity blocks, port 1 in each controller
pair connects to either I/O module A in the top capacity block or I/O module A in the bottom
capacity block.
•
When connecting the capacity blocks together, connect I/O module A on each capacity block
in a "top to bottom" order; connect I/O module B in each capacity block in a "bottom to top"
order.
Figure 25 HP StoreAll 8800 Storage system cabling with one ENT SAS capacity block
1. SAS ENT capacity block
2. HP StoreAll node 1, port 2 in slot 1 to SAS ENT capacity block (port 1 of I/O module B)
3. HP StoreAll node 1
4. HP StoreAll node 2
5. HP StoreAll node 2, port 2 in slot 1 to SAS ENT capacity block (port 2 of I/O module B)
6. HP StoreAll node 2, port 1 in slot 1 to SAS ENT capacity block (port 2 of I/O module A)
7. HP StoreAll node 1, port 1 in slot 1 to SAS ENT capacity block (port 1 of I/O module A)
Cabling HP StoreAll Storage system components 33