15-18
12) Remove the tilting bolt cap and loosen the 25 x 2.0 mm self-
locking nut or the 7/8-14 UNF self-locking nut.
13) Holding the power trim/tilt assembly with the hands,
extend the L./R. stern brackets to the right and left and
remove the lower cylinder collar and the two 32 mm wave
washers.
14) Pull off the wires and tube through the hole in the L. stern
bracket and remove the power trim/tilt assembly.
Check the lower cylinder bushings mounted on the power
trim/tilt assembly for damage. Replace the bushings with
the new ones if necessary.
15) Remove the lower cylinder bushings.
Replace the lower cylinder bushings with the new ones on
assembly.
• Do not push in the piston rod after removing the power
trim/tilt assembly.
If the piston rod is pushed down, extend the piston rod
fully and hold it in the position.
• Store the power trim/tilt assembly vertically with the
upper cylinder pin installation part facing up after
removal. Never store the power trim/tilt assembly by
laying it on its side or with the lower cylinder collar
installation part facing up.
• If it is hard to remove the lower cylinder collar, loosen the
25 x 2.0 mm self-locking nut again.
NOTICE
[3]
25 x 2.0 mm SELF-
LOCKING NUT
[1] TILTING BOLT
CAP
[3] POWER TRIM/TILT
ASSEMBLY
[5]
32 mm WAVE
WASHER (2)
[2] LOWER
CYLINDER
COLLAR
[1] R. STERN
BRACKET
[6]
L. STERN
BRACKET
[2] 7/8-14 UNF SELF-
LOCKING NUT
[4] LOWER CYLINDER
BUSHING (2)
[8]
LOWER CYLINDER
PIN INSTALLATION
PART
[7]
UPPER CYLINDER
PIN INSTALLATION
PART