![background image](http://html1.mh-extra.com/html/honda/marine-bf135a/marine-bf135a_manual_2157757491.webp)
14-24
6) Apply gear oil to the circumference of the new bearing.
7) Install the bearing on the revere bevel gear using the
special tools and the hydraulic press.
TOOLS:
Driver
07749-0010000
Attachment, 62 x 68 mm
07746-0010500
Pilot, 35 mm
07746-0040800
Install the bearing holding the inner part of the bearing.
NOTICE
8) Apply gear oil to the circumference of the thrust bearing.
9) Soak the propeller shaft holder in the container filled with
oil with the reverse bevel gear/bearing assembly
installation side toward down.
10) Heat the oil to 80 – 90˚C (176 – 194˚F).
11) Check that there is no groove at the spline of the propeller
installation side of the propeller shaft.
12) After the entire of the propeller shaft holder becomes hot,
remove the holder from the container, and install the thrust
bearing washer, thrust bearing, propeller shaft and the
reverse bevel gear/bearing assembly in this order quickly
on the propeller shaft holder.
Note to install the thrust bearing water with the chamfered
side toward the holder.
• Do not heat the oil above 90˚C (194˚F).
• The entire holder becomes hot. Be sure to wear the
gloves during the operation.
13) Apply grease to the circumference of the new 105 x 3.1 mm
O-ring and install it on the propeller shaft holder.
Wait until the propeller shaft holder cools down before
installing the O-ring.
NOTICE
NOTICE
[1]
DRIVER
07749-0010000
[2]
ATTACHMENT,
62 x 68 mm
07746-0010500
[3]
PILOT, 35 mm
07746-0040800
[5]
REVERSE BEVEL
GEAR
[4]
50 x 90 x 20 mm
RADIAL BALL
BEARING
[2]
PROPELLER
SHAFT HOLDER
[2]
PROPELLER
SHAFT
HOLDER
[5]
PROPELLER
SHAFT
[7]
CHAMFER
[1]
THERMOMETER
[4]
REVERSE BEVEL
GEAR/BEARING
ASSEMBLY
[3]
Heat the oil to 80 – 90˚C
(176 – 194˚F).
[8]
THRUST
BEARING
[6]
THRUST
BEARING
WASHER
[5] Groove
[2] No groove
[3]
PROPELLER SHAFT
[3]
PROPELLER SHAFT
[1]
<LC, XC, LD and XD types>
[4]
<XCC, LCD and XCD types>