6-19
7) Check the rotor slip rings for contamination with grease.
If it is contaminated with grease, wipe it off thoroughly with
a clean cloth.
Install the rotor on the stator [drive end housing].
Install a bearing cover on the rotor shaft.
8) Apply grease to the surface of the rear bearing and install
the wave washer.
9) Pass the wire through the respective four holes in the rear
housing.
Install the rear housing on the stator [drive end housing]
and tighten the two 5 mm hex. nuts and the rear housing
bolts securely.
• Install the rear housing aligning the outer side of the
wave washer with the outer side of the bearing.
[3]
STATOR
[DRIVE END
HOUSING]
[1]
BEARING
COVER
[4]
ROTOR
[2]
SLIP RINGS
[6]
WAVE
WASHER
[4]
REAR
HOUSING
[2]
REAR HOUSING
BOLT (2)
[3]
5 mm HEX.
NUT (2)
[1] HOLES
(Four places)
[5]
WIRES