6-21
15) Tighten the two 4 x 25 mm screw-washers and the two 4 x
6 mm screws securely while pushing the brush of the IC
regulator/brush holder assembly, assembled in step 14,
lightly against the rotor shaft slip rings.
Tighten the 4 x 6 mm screw securely that has been
tightened loosely in step 14.
Take care not to damage the rotor shaft slip rings with the
brush during installation.
NOTICE
16) Install the rear end cover and tighten the three rear end
cover bolts securely.
17) Install the insulator bushing and tighten the 6 mm hex. nut
securely.
[1] 4 x 6 mm SCREW (2)
[2]
4 x 25 mm SCREW-
WASHER (2)
[4]
SLIP
RINGS
[3]
IC REGULATOR/BRUSH
HOLDER ASSEMBLY
[2] REAR END
COVER
[1] REAR END
COVER
BOLT (3)
[4]
6 mm HEX. NUT
[3]
INSULATOR
BUSHING