15-45
18) Holding the piston rod B in place, loosely tighten the rod
guide comp. on the cylinder comp.
• Do not install the piston rod Bs by pushing them into
respective trim cylinders.
19) Using the special tool, tighten the left and right rod guide
comps. to the specified torque as shown.
TOOL:
Pin wrench, 4 mm
07SPA-ZW10200
TORQUE: 78 N.m (8.0 kgf.m, 58 lbf.ft)
20) Check the manual valve and the O-ring for deterioration,
wear and damage. Replace the manual valve with a new
one if necessary.
21) Apply Automatic Transmission Fluid (ATF) to the manual
valve O-ring.
Set the manual valve on the pump assembly and tighten it
to the specified torque.
TORQUE: 3.5 N.m (0.35 kgf.m, 2.5 lbf.ft)
22) Install the internal circlip securely in the groove in the
pump assembly.
23) Apply Automatic Transmission Fluid (ATF) to the five new
O-rings and the orifice collar.
Set the five O-rings and the orifice collar in the indicated
position of the cylinder comp.
24) Install the pump assembly on the cylinder comp. with the
socket bolt A and B.
Tighten the socket bolt A and B to the specified torque.
TORQUE: 8.5 N.m (0.85 kgf.m, 6.1 lbf.ft)
25) Fill the pump assembly with the fresh Automatic
Transmission Fluid (ATF).
• Do not fill up the pump assembly quickly. Pour the
Automatic Transmission Fluid (ATF) in the pump
assembly slowly.
(ATF)
[1] PUMP
ASSEMBLY
[2]MANUAL
VALVE
[3]INTERNAL
CIRCLIP
[1]
PUMP ASSEMBLY
[1]
ROD GUIDE
COMP.
[2] PIN WRENCH,
4 mm
07SPA-ZW10200
[4] ORIFICE
COLLAR
[3]
O-RING (5)
[2]
PUMP ASSEMBLY
[1]
SOCKET
BOLT B (2)
[5] SOCKET BOLT A
(ATF)