4-34
19) After installing the cover lock cable A and B, operate the
cover lock lever and check the front lock and the L./R. side
locks for smooth operation.
20) Pull up the cover lock lever (i.e. release the cover lock).
Look down the cover lock bolt hole of each of the under
cover front bracket and the L./R. side cover brackets and
check that the front lock and the side lock do not appear.
21) If the front lock or side lock appears when looking down the
cover lock bolt hole, perform the following check.
<When L. side bracket side appears>
Loosen the lock nut at the cover lock cable A of the L. side
bracket, and adjust by turning the adjusting nut right or left.
<When R. side bracket side appears>
Loosen the lock nut at the cover lock cable B of the R. side
bracket, and adjust by turning the adjusting nut right or left.
22) Install the following parts.
– Remote control cable/grommet (P. 17-5)
– L./R. engine under cover (P. 4-14)
– Front separate cover (P. 4-7)
– Engine cover (P. 4-2)
16) Adjust the length between the other end of the cable outer
and the end of the nut of the cover lock cable B so that it is
13 mm (0.5 in) as shown.
17) Holding the nut in the position described in step 16,
position the inner cable end of the cover lock cable B on the
side lock and position the cable B nut on the R. side cover
bracket.
Tighten the washer side lock nut securely.
• Check that the nut set in step 16 is not out of the position.
If it is, repeat the procedure from step 16.
18) Check for clearance between the end of the long hole in the
side lock and the inner cable end as shown. There must be
no clearance.
If there is clearance, repeat the procedure from step 7.
Check that the side lock is in contact with the stopper of the
R. side cover bracket.
13 mm
(0.5 in)
[2]
R. SIDE
COVER
BRACKET
SIDE
[7] LOCK NUT
[1]
COVER LOCK
CABLE B
[4]
STOPPER
[3] Contact.
[6] SIDE LOCK
[1] View of each bracket from the top:
[3]
COVER LOCK
BOLT HOLE
(The front lock
and side lock
must not appear
when viewing the
cover lock bolt
hole from the top
with the lever
pulled up.)
[2] FRONT LOCK
or SIDE LOCK
[5] No clearance.
[4] L. SIDE COVER BRACKET SIDE:
[6] LOCK NUT
[7] ADJUSTING NUT
[5] COVER LOCK
CABLE A