HNC Electric HV590 Series, Руководство пользователя

Страница: 89 / 192

75
Section V. Parameter Function Table
Y1P terminal output pulse frequency range
：
0.01kHz~P5.09(Y1P maximum frequency output), P5.09
could vary from 0.01kHz to 100.00kHz.
AO1, AO2 output ranges from 0V to 10V, or 0mA to 20mA.
The corresponding value range is shown in the table below
：
Setup
value
Function Range
0 Running frequency
0~maximumoutputfrequency
1 Setupfrequency 0~maximumoutputfrequency
2 Outputcurrent
0~200%ofthe rated current oftheinverter
3 Outputtorque 0~200%ofthe rated torque oftheinverter
4 Outputpower
0~200% ofthe rated powerofthe inverter
5
Output voltage
0~120% of the rated voltage of the inverter
6 PULSEpulse input 0.01kHz~100.00kHz
7 AI1
0V~10V
8 AI2
0V~10V(Or 0~20mA)
9 AI3 0V~10V
10
Length
0~Maximum length
11 Countingvalue 0~Maximum counting value
12
Communication setup 0.0%~100.0%
13
Motor revolving speed
0~maximum output frequency corresponding speed
14
Output current
0.0A~1000.0A
15
Output voltage
0.0V~1000.0V
P5.09
Y1P maximum output
frequency
0.01kHz~100.00kHz 50.00kHz
☆
When the multifunctional terminal output function selects Y1P pulse output, it can set the maximum
frequency value of output pulse.
P5.10 AO1 zero offset -100.0%~+100.0% 0.0%
☆
P5.11 AO1 gain -10.00~+10.00 1.00
☆
P5.12
Expansion card AO2zero
offset
-100.0%~+100.0% 0.00%
☆
P5.13 Expansion card AO2 gain -10.00~+10.00 1.00
☆
Function codes above are generally used to modify the zero drift of the analog output and also be
used to define required AO output curves.
If b represents zero offset, k represents gain, Y represents actual output, and X represents standard
output, the actual output is calculated as follows
：
Y=kX+b
AO1, AO2 zero offset coefficient 100% corresponds to 10V (20mA).
For example, if the analog output is the running frequency, and it is expected to output 8V (16mA)
when the frequency is 0, and output 3V (6mA) at the maximum frequency, the standard output 0V to 10V
shall be modified to 8V to 3V output. As per the above formula, AO zero offset coefficient shall be set to
“80%”, while A0 gain shall be set to “-0.50”.