HNC Electric HV590 Series, Руководство пользователя

Страница: 108 / 192

94
Section V. Parameter Function Table
17 17=Err17
Contactor fault
18 18= Err18
Current inspection fault
19 19= Err19
Motor tuning fault
20 20= Err20
Encoder /PG card fault
21 21= Err21
EEPROM read & write fault
22 22= Err22
Inverter hardware fault
23 23= Err23
Short circuit to ground fault
24 Reserved Reserved
25 Reserved Reserved
26 26= Err26
Total running time arrival fault
27 27= Err27
User-defined fault 1
28 28=Err28
User-defined fault 2
29 29=Err29
Total power-on time arrival fault
30 30= Err30
Load off fault
31 31= Err31 PID feedback loss during operation fault
40 40= Err40
Each wave current limiting fault
41 41=Err41
Motor switching fault
42 42= Err42
Excessive speed deviation fault
43 43= Err43 Motor overspeed fault
45 45=Err45
Motor overtemperature fault
51 51= Err51
Initial position fault
P9.17
Third fault frequency The latest fault frequency
●
P9.18
Third fault current The latest fault current
●
P9.19
Third fault bus voltage The latest fault bus voltage
●
P9.20 Third fault input terminal
The latest fault digital input terminal status, order as below
：
When in
put terminal status is ON, it’s corresponding
binary digit is 1. OFF corresponds to 0. All DI status are
converted to decimal display.
●
P9.21 Third fault output terminal
The latest fault digital output terminal status, order as
below
：
When out
put terminal status is ON, it’s corresponding
binary digit is 1. OFF corresponds to 0. All status are
converted to decimal display.
●
BIT9 BIT8 BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
DI1 DI2 DI3 DI4 DI5 DI6 DI7 DI8 DI9 DI0
BIT4 BIT3 BIT2 BIT1 BIT0
FMP REL1 REL2 DO1 DO2