Hitachi FSG Series, Технический каталог

Страница: 400 / 424

18
/8
TROUBLESHOOTING
18.3.2 CONTENTS OF CHECK MODE 2
The latest data of the first three indoor units only connected
serially are indicated when more than three indoor units are
connected to one remote control switch.
By pressing the "
}
" part of "TEMP" switch, the next display
is indicated. If the part "
~
" of "TEMP" switch is pressed, the
previous display is indicated.
Temperature indication
91 23
1
Indoor Unit
Intake Air Temp.
at Thermistor (°C)
¯
92 50
2
Indoor Unit
Discharge Air Temp.
at Thermistor (°C)
¯
93 25
3
Indoor Unit Exchanger
Liquid Pipe Temp.
(Freeze protection) (°C)
¯
94 12
4
Outdoor Aire
Temperature (°C)
¯
95 25
5
Indoor Heat
Exchanger gas Pipe
Temp. (°C)
¯
96 03
6
Evaporating Temp. at
Heating (°C)
¯
97 --
7 Control information
¯
98 45
8
Discharge Gas Temp.
at the Top of Comp.
Chamber (°C)
¯
to next page
This is an indication for internal information for the remote control
switch.
This does not have any specific meaning.
The average temperature is indicated when two compressors are
running
Normal
Abnormal
. . .
Temperature displayed
– –
129
(Thermistor Open circuited
or PCB defected)
(Temp. for Top of Comp.)
FF
or
(Thermistor Short circuited
or PCB defected)
255
or
127
or
(Temp. for Top of Comp.)
Indication of Category Code
Indication of Temperature, etc
See "18.6 Self-Checking of PCB's
using Remote Control Switch"
?
NOTE:
1. During a transient period such as starting time, etc. "--" may be
indicated for a limited time.
2. All the data during check mode 2 will be changed to "00" if a
power failure occurs during alarm indication.