Hitachi FSG Series, Технический каталог

Страница: 361 / 424

INSTALLATION OF OPTIONAL REMOTE CONTROLLER
16
/17
16.3.7 INITIALIZATION OF CENTRAL STATION
The procedure for initialization of the group setting and the
optional setting is as follows
1. Changing to Self Check Mode
Depress the "GROUP (
)
and
(
)" and "MODE"
switches simultaneously, the central station is
changed to the self check mode. In case that there is a
group in operation, the "NO FUNCTION" is indicated
and the central station can not be changed to the self
check mode.
After changing to the self check mode, the LCD
indication is changed from (i) to (vii) as shown below.
Before the indication is changed to (vii), depress the
"GROUP (
)
and
(
)" and "MODE" switches
simultaneously again and remain pressed until
initalization starts, and the central station is changed
to the initializing mode.
(i)
(ii)
(iii)
(iv)
(v)
(All indications: OFF)
(vi)
(All indications ON)
(vii)
(All indications: OFF)
NOTE:
In case that "GROUP (
)
and
(
)" and "MODE"
switches are not depressed again, the self check
operation continues.
2. Initialization
When the central station is changed to the initialization
mode, the LCD indication on the central station is as
shown below. In this condition, depress the "RESET"
switch, and the flickering "06" indication is changed to
ON and the initialization is performed.
(In case that initialization is not required, depress the
"CHECK" switch, the LCD is automatically changed as
shown below).
"06" flickers. Depress "RESET"
switch and "06" is changed to
ON. In case of EEPROM
initialization, it takes
approximately 30 - 60 seconds
Depress "RESET" or "CHECK"
switch
To Connection Check
Group Setting Table of Central Station
RSW of
Indoor
Unit
0 1 2 3 4 5 6 7 8 9 A B C D E F
Indication
of PSC-5S
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
Fill the gap number (1-16) in the above table
Circle the unit number of the master unit