Hitachi FSG Series, Технический каталог

Страница: 350 / 424

16
/6
INSTALLATION OF OPTIONAL REMOTE CONTROLLER
Address of Indoor Units:
Main unit 1
st
unit 2
nd
unit 3
rd
unit 8
th
unit 9
th
unit 10
th
unit 11
th
unit
4
th
unit 5
th
unit 6
th
unit 7
th
unit 12
th
unit 13
th
unit 14
th
unit 15
th
unit
16.2 INSTALLATION OF REMOTE CONTROL SWITCH (CORE-FUNCTION) <PC-P5H>
n
Selection of Installation Place
§
Select a suitable place for handling and determine the
installation place of the controller with the customer’s
acceptance.
§
Do not install the controller at such places as:
– Where children can touch
– Where the air from the air conditioner is directly
discharged
n
Before Installation
Check the contents and the number of the accessories in
the packing.
Remote Control
Switch, for
Operation Control 2 screws
Ø4x16L
For fixing the
Holding Bracket
onto the wall Ring
Core1 Band
For fixing
Cable to
Ring
Core Cable
(20 cm)
n
Installation Space
§
In case of installing the controllers in vertical line, keep
a distance more than 50mm between the controllers
vertically.
If the distance is insufficient, the front cover of the
controller can not open wide enough.
More than
50 mm
n
Installation Procedures
1. Insert the edge of the screwdriver into the groove parts at
the bottom of the holding bracket, push and turn the
screw driver and remove the controller from the holding
bracket
.
Figure seen from Bottom Side
Groove Part Screw Driver
2. Connection of cable.
Connect the accessory cable to the fielded cable by
soldering.
Accessory Cable Field Supplied Cable
(Insulate the connecting part by vinyl tape)
3. Attach the controller to the holding bracket and connect
the cable as follows.
In Case of Exposing Remote Control Cable
Fix the Holding Bracket onto
the wall with screws
(Accessory)
Approx. 6 mm