155
_____________________________________________________________________________________________
6.4 File Screen
______________________________________________________________________________________________
6.4.6 Saving the Area & Modes (ROM)
Command:
AREA MODE
If a file with the same name already exists,
a warning message will appear
NOTE
NOTE
Saves all comparison areas A01 to A16 and comparison conditions
MODE01 to MODE16 in 8730-10, 8731-10 internal memory at once.
Only the comparison areas and comparison conditions saved in internal
memory are saved to a PC card.
The comparison areas and comparison conditions are restored when
loaded.
For information on saving comparison areas, see 11. in 5.3.3.
For information on saving comparison conditions, see 5.2.4.
Procedure
1. Press the
FILE
key, and display the File
screen.
2. Press the left
CURSOR
key to move the
cursor to a command.
3. Select "
AREAMODE
", then press the
ENTER
key.
4. Enter a filename. For details, see 8. in
3.1.2.
5. Press the
START
key to save the data;
press the
STOP
key to cancel.
Starts saving.
Cancels saving
Do not change the folder name.
Because folder information is contained in
the index file, renamed folders are
inaccessible.
If the amount of data is too large, the data may not be successfully saved on the PC card. For details,
see 13.3.
Executing the save command creates an index file (in ROM) using the name specified in step 4. above
and a directory with the same name. The data (SET) for comparison conditions MODE01 to 16 and
data (ARE) of areas A01 to A16 will be saved in the directory. This data can be loaded individually.
Loading an index file (ROM) loads all comparison conditions MODE01 to 16 and areas A01 to A16 at
once.
Only the data saved in internal memory is saved.
If a file with the same name already exists, a warning message will appear. Rename the file in
step 4. above or save the file by one of the following two methods:
OVER WRITE : Overwrite the existing file.
NUMBERING : Append a number to the filename.
