GE Vivid S5 N, Руководство по обслуживанию

Страница: 679 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-153
P R E L I M I N A R Y
8-6-9 PIB (Probe Interface Board) Board Replacement Procedure
8-6-9-1 Tools
Use the appropriate flat and Phillips-type screwdrivers as indicated in the PIB replacement procedure.
8-6-9-2 Time Required
10 minutes
8-6-9-3 Preparation
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in 4-2-3 "Power Shut Down" on
page 4-7 .
8-6-9-4 PIB Board Removal Procedure
1) Remove the system left and right side covers, as described in the “Left Side Cover Removal
Procedure” on page 8-6 and “Right Side Cover Removal Procedure” on page 8-5 .
2) Remove the system front cover, as described in the “Front Cover Removal Procedure” on page 8-17 .
3) Remove the cabinet cage assembly from the system, open the cage and carefully place it on a
stable surface, as described in the “Cabinet Cage Assembly Opening and Removal Procedure” on
page 8-109 .
4.) Unfold the cabinet cage assembly, as described in “Opening and Removing the Cabinet Cage
Assembly” on page 8-109 (see step 11 on page 8-112).
5) Remove the screw that secures the PIB-to-PSB flex cable in position ( Figure 8-188 ).
NOTICE
When performing these procedures, take precautions to avoid damage of
electrostatic-sensitive components. Always have the ESD wrist strap
connected either to the DIB chassis or to the GND plug at the rear of the
scanner, and to your hand.
If a battery is present, first remove the battery as it contains stored energy.
Refer to
“Battery Removal Procedure” on page 8-116 .
Figure 8-188 Unscrewing the PIB-to-PSB Flex Cable