GE Vivid S5 N, Руководство по обслуживанию

Страница: 631 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-105
P R E L I M I N A R Y
3.) To complete the procedure, disconnect the relevant cables from the Distribution Interface Board
(DIB); see Figure 8-126
.
8-5-1-4 Keyboard and Monitor Cable Installation Procedure
1.) Re-connect all the relevant cables (including the new Keyboard power cable and Monitor cable) to
the Distribution Interface Board (DIB); see Figure 8-126
.
2.) Re-fit the central metal bracket, as indicated in Figure 8-125 .
3.) Return the system covers, as described in the following procedures (see also):
• “Front Cover Installation Procedure” on page 8-19
• “Right Side Cover Installation Procedure” on page 8-5
• “Left Side Cover Installation Procedure” on page 8-7
4.) Proceed to route the following four cables up through the aperture in the base of the Keyboard
Interface Assembly, working in the following order:
a.) LCD power cable - refer to Figure 8-123 .
b.) DVI cable - refer to Figure 8-122 .
c.) 90° Data - refer to Figure 8-121 .
d.) USB cable - refer to Figure 8-120 .
5.) Fasten the two lower cable securing brackets, as indicated in Figure 8-119 .
6.) Return and fasten the two upper cable securing brackets (previously removed), as indicated in
Figure 8-118 . (Use a Phillips screwdriver to carefully tighten the screw
s)
Note: Before the next procedure, it is recommended to lean the keyboard interface platform
backwards and to place protective material between the lower arm and the handle, as
indicated in
Figure 8-117 .
Figure 8-126 Cables Connected to Distribution Interface Board