GE Vivid S5 N, Руководство по обслуживанию

Страница: 504 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
7-120 Section 7-6 - Performing Back End Diagnostics on the System
P R E L I M I N A R Y
7-6-1 Accessing the Back End Diagnostic Test Options
(cont’d)
6.) To resume testing (from the point where you paused), trackball to the Start button and press Set .
When the CPU Full Test sequence is complete:
- the Diagnostic Test window displays the Finished message
- the View Test Log window opens automatically, listing all tests performed and showing details
of which tests and sub-tests passed or failed, as shown in the example in Figure 7-78 "View
Test Log - Full Back End Test w/o Hard Disk Scan" on page 7-116 .
NOTE: For the CPU Full Test, many tests are performed in the test sequence; these are listed in the
Tests window as shown in
Figure 7-80 . For each currently-selected test (for example,
Registers) the corresponding report is listed in Reports on the right.
7.) Use the scroll bars and/or arrows to scroll through the list of Test results and review the reports, as
required:
- CPU Registers
- CPU Arithmetics
- CPU String Operations
- CPU Logical Operations
- CPU Math Registers
- CPU Math Commands
- CPU Transcendental
- CPU MMX Arithmetic
- CPU MMX Logical
- CPU MMX Shift
- CPU MMX Data Transfer
- CPU MMX Misc.
8) When done, trackball to the Exit button and press Set to close the View Report window.
9) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If no problems were identified but the problem persists, contact your local GE HEALTHCARE
field engineer for assistance.
• If errors were identified and the results were not marginal, verify that all system cables and
boards are connected (not misplaced) and functioning properly, as described in Chapter 5 -
Components and Function (Theory) .
Figure 7-82 View Test Log - CPU Full Test