GE Vivid S5 N, Руководство по обслуживанию

Страница: 652 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
8-126 Section 8-6 - Lower Section Components Replacement Procedures
P R E L I M I N A R Y
5.) Insert the appropriate software installation CD into the CD drive.
The following options are displayed:
NOTE: If you need to abort the process at this stage, prior to formatting, do so by pressing the On/Off
switch and holding down for a few seconds until the system shuts down.
6.) Select the appropriate formatting action corresponding with your system’s software installation.
The following screen displays:
7.) Select “ Y ” to continue with the formatting process or “ N ” to restart the procedure.
T he system will start the formatting procedure and reboot automatically.
After rebooting, the system will boot from the software installation CD.
8.) Perform a “Full Clean Install” software procedure corresponding to the BT level of your system.
- Refer to the “Software Upgrade Procedure Overview” on page 8-207 .
Note: IMPORTANT - if both the Hard Disk and Back End are being replaced simultaneously, it is
necessary to re-configure the LCD type as described in “Display Type Setup” on page 6-8 .
9.) When done, proceed to perform the following functionality tests:
- “Software Configuration Checks” on page 4-45
- “Calibration” on page 7-12
- “Full System Test” on page 7-11
10.)After you have completed the formatting procedure, store the Formatting Utility Disk at the
customer’s site where it can be accessed for future use.