GE Vivid S5 N, Руководство по обслуживанию

Страница: 292 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
4-22 Section 4-3 - Functional Checks
P R E L I M I N A R Y
4-3-1-5 Light Detector Test for Vivid S6 N only
4-3-1-6 Monitor Test
This procedure is performed in stages, in the order shown in the table below. First, verify the monitor
settings and then proceed with the tests that follow.
Table 4-9 Light Detector Test
Step Task Expected Result(s)
1
Boot-up the System in Regular Scanning Mode.
2
Press LCD (F4 Key) to start the LCD adjustment.
3
Rotate the Brightness, Contrast and Blue Tint to max
values. LCD adjustment will change; the status bar for each of
the three parameters will move to the max position.
4
Select AutoAdjust on the softkey menu.
The Screen will change Brightness, Contrast and Tint
parameters to in accordance with the environmental
lighting.
Table 4-10 Monitor Test
Step Task Expected Result(s)
VERIFY MONITOR SETTINGS
1
Boot-up the System in Regular Scanning Mode
2
Press Config
3
Under the Connectivity tab, select TCPIP
4
Select Advanced
5
In the address bar, type Control panel and
press Enter
6
From the Control Panel, select Display then
select Settings
Make sure resolution is set to 800 x 600 pixels, 16 bit.
If not, select the correct resolution settings.
7 From the Settings Tab, select Advanced .
Select Intel® Extreme Graphics2 for mobile
> Graphics Properties > Video Overlay .
Make sure the settings are:
• Gamma = 0
• Contrast = 50
• Saturation = 50
• Brightness = 7
• Contrast = 1
8
When done, press OK to close all windows.
LCD PIXEL TEST:
1
Boot-up the System in Maintenance Mode
2
Press Alt +Config to start the diagnostic
package
3
From the Diagnostic Test Tree, select Back
End .
This will activate PC Doctor diagnostics.
4
Run the System Diagnostics\Monitor Test.