GE Vivid S5 N, Руководство по обслуживанию

Страница: 433 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-49
P R E L I M I N A R Y
7-4-4 TR 32 Diagnostic Tests
(cont’d)
NOTE: For this test, there are two reports (MLA0 and MLA1) which is listed in Reports on the right. By
default, the MLA0 report is displayed in the Reports window below, showing the results for both
the TR32A and TR32B boards (
Figure 7-23 "View Test Log - TR32 BF Digital Test (MLA0)" on
page 7-48 ).
9.) To view the MLA1 test results in the Report window, select MLA1 test results under Reports.
The MLA1 report is displayed in the Reports window below:
10) When done, trackball to the Exit button and press Set to close the View Report window.
11) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If no problems were identified but the problem persists, contact your local GE HEALTHCARE
field engineer for assistance.
• If errors were identified but the results were marginal, perform calibration, as described in
“DC Offset Calibration” on page 7-27 , and then repeat the test.
• If errors were identified and the results were not marginal, verify that all system cables and
boards are connected (not misplaced) and functioning properly, as described in Chapter 5 -
Components and Function (Theory) .
If the problem persists, this indicates that either the specific board you tested is faulty or that
another board that supports the operation of that board is faulty. Contact your local
GE HEALTHCARE field engineer for assistance.
12.)Trackball to the Exit button and press Set to close the View Test Log dialog box.
13.)Press the < Esc > button on the keyboard to close the Diagnostic Test Window .
Figure 7-24 View Test Log - TR32 BF Digital Test (MLA1)