Operator’s Manual: ThermoJet
Chapter 5: Display Screens
© SP Industries, Inc.
200-31974-999 Rev. 009
25
Manual Mode Features
The Manual Mode Screen allows operator access to manual operation, temperature control and
other operating modes.
A setpoint is entered by highlighting the desired data field, typing in a number on the pop up
keypad and pressing the enter button. Activate the setpoint by pressing the button immediately to
the left of the desired value (Set 1, Set 2 or Set 3). When chosen, the controller setpoint is
stepped to the new value.
If the unit is in Nozzle Control mode only, the nozzle temperature will be displayed. If the unit is in
DUT control mode, both the nozzle temperature and the DUT temperature will be displayed. The
control mode is set on the Control Status Screen and can be accessed via the Utilities Screen.
The air flow can be set by highlighting the appropriate data field and entering the desired value.
The four Main Menu Buttons, located at the bottom of most screens, allow the user to move
seamlessly from one screen to another. The gray button color indicates the active screen.
Figure 9 – Manual Mode Screen
The “Up Counter” displays the length of time that the system has been controlling at the specified
setpoint (within the user defined dead-band). It has an infinite counting capability in seconds.
Manual Mode Screen
Power Down
Status window displays
The system’s current state
Displays Up Counter
User may enter and
switch between three
temperature setpoints
Main menu buttons
Displays nozzle air
temperature in Degrees C
Displays device under test
(DUT) temperature in
Degrees C
Display air flow in SCFM,
range 5 to 20
