ETC Element Classic, Руководство пользователя

Страница: 335 / 687

Single Cue Lists 321
If you apply the [Track] button to the delete instruction, the move instructions from cue 5 are
deleted and the values from cue 4 would then track into cue 6 and beyond.
Using the Cue List Index
The cue list index is a blind display list which shows the cue list you are working with, the cue
status, cue list properties, any other stored cue lists, and what (if any) faders the lists are
loaded onto.
When the cue list index is in focus, the following softkeys are available for editing the cue list:
{Partition}, {Autoblock Clean}, {Solo Mode}, {Execute} ,{Properties}, and {Edit}.
Opening the Cue List Index
You can access the cue list index by pressing [Cue] [Cue],[Tab] [1][6], or you can navigate
within the browser to Record Target Lists > Cue List Index and press [Select].
Cue list properties determine how the cue list will interact. Assigned properties will display at
the top of the cue list as well as any currently active show control triggers.
The top half of the cue list index displays all stored cues, including cue list properties, for the
selected cue list. The bottom half of the cue list index displays all stored cue lists and their
properties. The selected cue list is highlighted.
Using the mouse, you can move the barrier between the stored cue display (top) and the
stored list display (bottom). Hover the mouse arrow over the list boundary until it changes to
the move boundary icon. Then click and drag the boundary up or down to the desired height.
Command Line Behavior for Cue List Index
The command line while in the Cue List Index defaults to cue list selection. The softkeys that
display will default to cue list control.
[Next] and [Last] will select the next or last cue list if no cue list or a cue list but no cue is on
the command line.
When a specific cue is selected, [Next] and [Last] will move through the cues in that same list,
and the softkeys will change to be for a single cue control.
Partitions on Cue Lists
A partition ( About Partitioned Control (on page 532) ) may be assigned to a cue list. If a
partition has already been applied to a cue list, any channels not in the cue list's partition will
not be included in cues when they are stored or replayed.
Any data for a cue list that already existed before a partition is applied, will be maintained,
including data for channels not included in the partition. If data existed before the partition
was assigned, in blind, channels that are not in the partition will display without a channel
graphic, any levels will be in gray, and a small superscript N will display with it.
Assigned partitions will display at the top of the cue list index and in the PSD.
To assign a partition to a cue list:
•
[Cue] [n] [/] {Partition} [n] [Enter]
To remove a partition from a cue list:
•
[Cue] [n] [/] {Partition} [Enter]