QuadroM 32x/8L/26x/12Li/26xi Manual II: Administrator's Guide
Administrator’s Menus
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x)
19
Show
button is used to generate an FXO channels usage diagram chart
over the parameters selected above.
When this button is pressed,
FXO Channel Usage Statistics
chart
appears. It represents dependency between the time frame and the number
of calls performed during that period. Additionally it may display the
maximum number of calls performed in the selected time frame.
The
Line Status
for any shared
ISDN Trunks
on the Quadro displays the
state of the B1 and B2 channels and the information about the active calls
on them. This page includes a group of static and dynamic parameters.
Static parameters are always displayed. Dynamic parameters appear only
when an event takes place on the channel.
Fig. II-26: FXO Channel Usage Statistics chart
Static Parameters:
•
B channel
- the state of the channel (enabled or disabled)
•
State
- the current state of the channel (free, busy or N/A)
Dynamic Parameters:
•
Caller Party
- this parameter appears when a call is received and
indicates the caller address
•
Called Party
- this parameter appears when a call is placed and
indicates the destination address
•
Call Duration
- current call duration (in seconds)
The
ISDN Channel Usage Statistics
link is only present for local ISDN
lines (this option is not available for shared ISDN lines) and leads to the
page where diagram chart of ISDN trunks usage can be viewed.
Fig. II-27: Lines Status page
The
ISDN Channel Usage Statistics
page consists of following
components used to define the chart parameters:
Trunk
checkboxes are used to select the ISDN line number(s) over which
the ISDN traffic chart will be built. At least one Trunk checkbox should be
selected, otherwise error message appears.
Time range of statistic table
drop down list includes the period (in days)
statistics data that is to be collected and the corresponding diagram chart
that is to be built.
Incoming Calls
and
Outgoing Calls
checkboxes are used to select
whether the ISDN traffic statistics for only incoming or outgoing or for both
type of calls should be displayed in the diagram chart.
Maximum Active Calls
checkbox is used to have the number of maximum
active calls displayed in the diagram chart.
At least one of these checkboxes should be selected, otherwise error
message appears.
Fig. II-28: ISDN Channel Usage Statistics page
