QuadroM 32x/8L/26x/12Li/26xi Manual II: Administrator's Guide
Administrator’s Menus
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x)
100
The
Trunk CAS Signaling Settings
page lists the available
timeslots of the trunk with CAS signaling and their settings.
The
Incoming Interdigit Service
link leads to the page where the dial
plan for incoming E1/T1 calls from CO/PBX to the Quadro can be
configured.
Incoming Digits Timeout
text field requires a value between 0 and
20000 (in milliseconds) and is used to define the timeout during
which incoming digits from the destination party calling Quadro will
be collected before being applied as an incoming called number.
Signaling Standard
drop down list is available only in E1 mode
and is used to select the connection signaling standard.
Force Update
functional button is used to apply immediately the
new settings on the selected timeslot(s). This will force the
timeslot(s) to be restarted and any active connection on the
selected timeslot(s) will be interrupted.
Enable/Disable
functional buttons are used to enable/disable the
selected timeslot(s).
Select one or more timeslots and click on
Edit
to open the
CAS
Signaling Wizard
that guides through the key configuration
parameters specific to the timeslot.
Fig. II-181: Trunk CAS Signaling Settings page
The
CAS Signaling Wizard
offers a possibility to configure the selected timeslot(s) and provides a variable group of parameters depending on the
E1/T1 trunk configuration.
CAS Signaling Wizard – Page 1
allows to configure signaling type
settings and consists of following components:
Allowed Call Type
is used to select the allowed call directions:
incoming, outgoing or both.
Signaling Type
allows selecting the CAS signaling type.
Please Note:
R2 signaling (compelled and non-compelled) can be
used with an E1 interface both in User and Network modes.
Quadro with E1 interface in the CAS mode detects the busy tone
only in case of R2 compelled and non-compelled (both with and
without ANI) signaling types.
Force Update Timeslots
checkbox can be optionally selected in
order to apply new settings immediately. This will force the
timeslot(s) to be restarted and any active connection on the
selected timeslot(s) will be interrupted.
Please Note:
Quadro does not support the
Forward Digit
selected
on the CO when acting in the
User
mode with
CAS
Loop Start
signaling type.
Get PSTN/PBX Error Message
checkbox enables notification
message in case of outgoing calls to unreachable, incorrect or non
existent destination.
Fig. II-182: CAS Signaling Wizard – Page 1
When
Generate Progress Tone to PSTN/PBX
checkbox is selected, Quadro generates ring tones to incoming callers during E1/T1 call dialing. This
feature is mainly applicable to 2-stage dialing mode.
Enable Echo Cancellation
checkbox enables the echo cancellation mechanism on the selected timeslot(s).
When
Alternative Disconnection Mode
checkbox is selected, the Quadro will play a busy tone towards the PBX/CO if the call has been failed. After
60 second timeout, the Quadro will disconnect the call from PBX/CO and will stop playing the busy tone.
