QuadroM 32x/8L/26x/12Li/26xi Manual II: Administrator's Guide
Administrator’s Menus
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x)
109
The
Start
and
Stop
functional links are used to start/shutdown
the selected ISDN trunk(s). When an ISDN trunk is in a
shutdown state, ISDN calls cannot be placed or received.
The
Restart
functional link is used to bring channel(s) to the
initial idle state on both sides. When applying one of these
options, any active traffic on the channel(s) will be terminated.
The
Copy to Trunk(s)
functional link displays a page used to
choose a trunk to which selected trunk’s settings should be
copied to.
The
Restore Default Settings
functional link restores the
default signaling settings of the selected ISDN trunk(s).
Fig. II-194: ISDN Settings page
Clicking on the corresponding ISDN trunk will lead to the
ISDN wizard
where trunk’s ISDN signaling settings can be configured. The
ISDN Wizard
consists of several pages.
The
ISDN Wizard
–
ISDN Settings
allows you to choose the interface type and the connection type of the selected trunk(s).
The
Interface Type
drop down list allows you to select between the User and the Network interfaces. If the ISDN port of the Quadro is connected to
the CO then
User
interface type should be selected. If the ISDN port of the Quadro is connected to the PBX then
Network
interface type should be
selected (in that case Quadro acts as a CO for that PBX).
The
Connection Type
manipulation radio button group allows
you to choose the connection type for the selected trunk(s):
•
PTP (Point to Point)
In case of connection to the CO (
User
interface type is
selected on Quadro) choose this option if only Quadro is
connected to the ISDN trunk from CO (no other ISDN
devices are connected to the particular ISDN trunk from
CO besides the Quadro).
In case of connection to the PBX (
Network
interface type
is selected on Quadro) choose this option if only the PBX is
connected to the ISDN trunk from the Quadro (no other
ISDN devices are connected to the particular ISDN trunk
from the Quadro).
In both cases, with this selection, Quadro sets the TEI to
manually mode assigning the default value of 0. If needed,
that value can be changed later in the
Advanced Settings
page of ISDN Wizard.
Fig. II-195: ISDN Wizard – ISDN Settings
•
PTMP (Point to Multi Point)
In case of connection to the CO (
User
interface type is selected on the Quadro) choose this option if there can be other devices connected to
the same ISDN trunk from CO except the Quadro.
In case of connection to PBX (
Network
interface type is selected on the Quadro) choose this option if there can be other devices connected to
the same ISDN trunk from Quadro except for the PBX.
In both cases, with this selection Quadro sets the TEI to automatic mode.
Please Note:
Consult with your CO operator or network administrator before configuring the ISDN connection type.
The
ISDN Wizard
-
Page 2
content is dependent on the connection type selected on the previous page of
ISDN Wizard
:
The next page is
ISDN Wizard
–
MSN Settings
page which is
used to turn on the MSN configuration. It is recommended to
enable the MSN when there are multiple ISDN devices
connected to the same ISDN bus. If the MSN is enabled on this
page, the next page will require the MSN table configuration.
Fig. II-196: ISDN Wizard – ISDN PRMP Settings
