QuadroM 32x/8L/26x/12Li/26xi Manual II: Administrator's Guide
Moderator's Menus
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x)
165
Parameter
System Default Value
timeout is 30.
FXO Settings
8 FXO lines – all lines enabled, incoming and outgoing calls allowed and routed to
00 Attendant on all lines.
E1/T1 Settings
Trunk1 exists.
Trunk mode - E1,
Interface Type – User,
Signaling – CCS,
Line Code – HDB3,
Frame Mode – NO_CRC,
Line Build Out – 120-ohm,
Coding - a-law,
LoopBack Mode - No_loopback,
Clock Mode – Slave,
TEI mode – non automat, TEI address -0,
SAPI Value – undefined,
Alternative Disconnect Mode – enabled,
Excessive Ack. Delay T200 – 4000,
Idle Timer T203 – 12000,
T302 timer – 4000 ,
T309 timer – 0,
T309 timer – 60000,
D Channel Timeslot for Transmit/Receive – 16,
B channels - 1-31 timeslots are enabled,
Echo Cancellation - enabled for all B channels,
Channels Selection – preferred,
Channels Selection Ordering – ascending,
Bearer Establishment Procedure – on progress indication with in-band information,
Called Party Type of Number and Calling Party Type of Number – Unknown,
Called Party Numbering Plan and Calling Party Numbering Plan – ISDN/telephony
numbering plan,
Route Incoming Call to – 00,
Switch Type - primary_dss1,
Generate Progress Tone to PSTN/PBX – None,
Incoming Called Digits Size – 1,
Generate Progress Tone to IP – disabled,
Send ALERT Message on Call Routing – disabled,
Enable CLIR Service – disabled,
Enable Connect Acknowledge Option – enabled,
Override CLID with P-Asserted-Identity –disabled.
ISDN Settings
ISDN Trunks - Trunk 1-6 exists on QuadroM 12Li/26xi.
Settings for all available Trunks:
State – started,
Interface Type – User,
Connection Type - PTMP( Point To Multi Point),
Service Type – No MSN,
Route Incoming Call to - 00,
Use Default outgoing Caller ID – enabled,
Default outgoing Caller ID – undefined,
Advanced Settings – disabled.
External PSTN Gateways
Use PSTN lines of the other device - disabled,
Authorization Parameters – undefined.
Gain Control Settings
FXS lines:
Transmit Gain: - 6
Receive Gain: 0
FXO lines:
Transmit Gain: - 6
Receive Gain: 0
E1/T1 Trunk(For QuadroM32x):
Transmit Gain: 0
Receive Gain: 0
ISDN trunks:
Transmit Gain: 0
Receive Gain: 0
Voice Mail:
Recording Gain: 0
Playback Gain: 0
Audio Lines:
