Endress+Hauser Proservo NMS5, Руководство по эксплуатации

Страница: 49 / 162

Proservo NMS5
Hauser 49
6.4 Operation Command and New Operation Status
6.4.1 Operation Commands
Operation Commands can be sent the NMS5 from a host system. The following table explain the command
codes.
6.4.2 New Operation Status
The following table shows the new operation status, which is available when "NEW NMS STATUS", matrix
position GVH=272, is selected to "ENABLED".
Code Command Remarks
0 LEVEL
1 UP
2 STOP After weight calibration, STOP is set as a default operation command.
3 BOTTOM LEVEL
4 UPPER INTERF. LEVEL
5 MIDD.INTERF.LEVEL
6 UPPER DENSITY
7 MIDDLE DENSITY
8 DENSITY BOTTOM
9 REPEATABILITY
10 WATER DIP
Code Meaning NMS Display
0 No definition -
1 Displacer at reference position REFERENCE
2 Displacer hoisting up UP
3 Displacer going down DOWN
4 Displacer stop STOP
5 Level measurement, balanced LEVEL
6 Upper I/F level, balanced UPPER INTERF. LEV.
7 Middle I/F level, balanced MIDD. INTERF. LEV.
8 Bottom meas. Balanced BOTTOM LEVEL
9 Upper density finished UPPER DENSITY
10 Middle density finished MIDDLE DENSITY
11 Bottom density finished DENSITY BOTTOM
12 Release over tension RELE. OVER TENS.
13 Calibration activated CAL. ACTIVE
14 Seeking level LEVEL SEEKING
15 Following level LEVEL FOLLOWING
16 Seeking upper density UPP.DEN.SEEKING
17 Seeking middle density MID.DEN.SEEKING
18 Seeking bottom density BOT. DEN. SEEKING
19 Seeking upper I/F level UPP. INT. SEEKING
20 Following upper I/F level UPP. INT. FOLLOWING
6 Operation