Dell S4048-ON, Руководство по настройке

Страница: 584 / 1039

To display the configuration values for OSPF graceful restart, enter the
show run ospf
command for OSPFv2 and the
show
run ospf and show ipv6 ospf database database-summary commands for OSPFv3.
Fast Convergence (OSPFv2, IPv4 Only)
Fast convergence allows you to define the speeds at which LSAs are originated and accepted, and reduce OSPFv2 end-to-end
convergence time.
Dell Networking OS allows you to accept and originate LSAs as soon as they are available to speed up route information propagation.
NOTE: The faster the convergence, the more frequent the route calculations and updates. This impacts CPU utilization
and may impact adjacency stability in larger topologies.
Multi-Process OSPFv2 with VRF
Multi-process OSPF with VRF is supported on the Dell Networking OS. Only one OSPFv2 process per VRF is supported.
Multi-process OSPF allows multiple OSPFv2 processes on a single router. Multiple OSPFv2 processes allow for isolating routing
domains, supporting multiple route policies and priorities in different domains, and creating smaller domains for easier
management.Each OSPFv2 process has a unique process ID and must have an associated router ID. There must be an equal number
of interfaces and must be in Layer-3 mode for the number of processes created. For example, if you create five OSPFv2 processes
on a system, there must be at least five interfaces assigned in Layer 3 mode. Each OSPFv2 process is independent. If one process
loses adjacency, the other processes continue to function.
Processing SNMP and Sending SNMP Traps
Only the process in
default vrf
can process the SNMP requests and send SNMP traps.
NOTE: SNMP gets request corresponding to the OspfNbrOption field in the OspfNbrTable returns a value of 66.
OSPF ACK Packing
The OSPF ACK packing feature bundles multiple LS acknowledgements in a single packet, significantly reducing the number of ACK
packets transmitted when the number of LSAs increases.
This feature also enhances network utilization and reduces the number of small ACK packets sent to a neighboring router. OSPF
ACK packing is enabled by default and non-configurable.
Setting OSPF Adjacency with Cisco Routers
To establish an OSPF adjacency between Dell Networking and Cisco routers, the hello interval and dead interval must be the same
on both routers.
In Dell Networking OS, the OSPF dead interval value is, by default, set to
40 seconds , and is independent of the OSPF hello interval.
Configuring a hello interval does not change the dead interval in Dell Networking OS. In contrast, the OSPF dead interval on a Cisco
router is, by default, four times as long as the hello interval. Changing the hello interval on the Cisco router automatically changes the
dead interval.
To ensure equal intervals between the routers, use the following command.
• Manually set the dead interval of the Dell Networking router to match the Cisco configuration.
INTERFACE mode
ip ospf dead-interval <x>
Examples of Setting and Viewing a Dead Interval
In the following example, the dead interval is set at 4x the hello interval (shown in bold).
Dell(conf)#int tengigabitethernet 2/2
Dell(conf-if-te-2/2)#ip ospf hello-interval 20
Dell (conf-if-te-2/2)#ip ospf dead-interval 80
Dell(conf-if-te-2/2)#
584
Open Shortest Path First (OSPFv2 and OSPFv3)