Dell S4048-ON, Руководство по настройке

Страница: 118 / 1039

set local-preference value
• Specify a value for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric {+ | - | metric-value }
• Specify an OSPF or ISIS type for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric-type {external | internal | type-1 | type-2}
• Assign an IP address as the route’s next hop.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
• Assign an IPv6 address as the route’s next hop.
CONFIG-ROUTE-MAP mode
set ipv6 next-hop ip-address
• Assign an ORIGIN attribute.
CONFIG-ROUTE-MAP mode
set origin {egp | igp | incomplete}
• Specify a tag for the redistributed routes.
CONFIG-ROUTE-MAP mode
set tag tag-value
• Specify a value as the route’s weight.
CONFIG-ROUTE-MAP mode
set weight value
To create route map instances, use these commands. There is no limit to the number of
set
commands per route map, but the
convention is to keep the number of set filters in a route map low.
Set
commands do not require a corresponding
match
command.
Configure a Route Map for Route Redistribution
Route maps on their own cannot affect traffic and must be included in different commands to affect routing traffic.
Route redistribution occurs when Dell Networking OS learns the advertising routes from static or directly connected routes or
another routing protocol. Different protocols assign different values to redistributed routes to identify either the routes and their
origins. The metric value is the most common attribute that is changed to properly redistribute other routes into a routing protocol.
Other attributes that can be changed include the metric type (for example, external and internal route types in OSPF) and route tag.
Use the
redistribute
command in OSPF, RIP, ISIS, and BGP to set some of these attributes for routes that are redistributed into
those protocols.
Route maps add to that redistribution capability by allowing you to match specific routes and set or change more attributes when
redistributing those routes.
In the following example, the
redistribute
command calls the route map
static ospf
to redistribute only certain static
routes into OSPF. According to the route map
static ospf
, only routes that have a next hop of Tengigabitethernet interface 1/1
and that have a metric of 255 are redistributed into the OSPF backbone area.
NOTE: When re-distributing routes using route-maps, you must create the route-map defined in the
redistribute
command under the routing protocol. If you do not create a route-map, NO routes are redistributed.
Example of Calling a Route Map to Redistribute Specified Routes
router ospf 34
default-information originate metric-type 1
118
Access Control Lists (ACLs)