Dell PowerConnect W-Airwave, Руководство пользователя

Страница: 141 / 310

Dell PowerConnect W-AirWave 7.4 | User Guide Discovering, Adding, and Managing Devices | 141
Setting a Maintenance Window for a Device
AirWave Management Platform can automate the manual action of putting multiple devices into Manage mode
at once so that changes can be applied, and after the maintenance period is over, the devices automatically revert
to Monitor-Only mode.
Maintenance windows can be set as a one-time or recurring event on the APs/Devices > Manage and Groups >
Basic page. You can also use the Modify Devices link to add or delete maintenance windows to multiple selected
devices at once. Additionally, this feature can be used on Master Console to set maintenance windows for
multiple AMPs.
To set a maintenance window for a single device in APs/Devices > Manage, follow these steps:
1. Navigate to the APs/Devices > Manage page for a device.
2. At the bottom of the page, locate the Maintenance Windows section.
3. Select Add New AP Maintenance Window.
Figure 99
Add New Maintenance Window in APs/Devices > Manage page
4. Enter a name for the maintenance window.
5. In the Occurs field, specify whether the maintenance window should occur one time, or daily, weekly,
monthly, or annually.
6. Set the desired start time and the duration (in minutes) of the maintenance window.
7. Select Add.
Configuring Device Interfaces for Switches
When you go to the APs/Devices > Interfaces page for a switch, you can add a Virtual interface by selecting Add
and entering the appropriate information in the page that then appears, as shown in
Figure 100 .
IP Address None The IP address of the controller.
Subnet Mask None The subnet mask for the controller.
Gateway None The controller's gateway.
Primary and Secondary
DHCP Servers None The DHCP servers for the controller.
Guest LAN Disabled Indicates a guest LAN.
Quarantine VLAN ID Disabled Enabled indicates it is a quarantine VLAN; used only for H-REAP-associated clients.
Dynamic Device
Management Enabled When enabled, makes the interface an AP-manager interface. Cisco calls this feature
Dynamic AP Management.
Table 86
APs/Devices > Manage > Interface Fields and Descriptions for Cisco WLC Devices (Continued)
Field Default Description