Daikin RXYQ96PYDN, Руководство по обслуживанию

Страница: 243 / 567

Test Operation SiUS34-801A_b
228 VRVIII R-410A Heat Recovery 60Hz
[How to Check How Many Units are Connected]
It is possible to find out how many indoor or outside units in the system are turned on by operating
the push button on the PC-board (A1P) of outside unit (In case of multi system master unit).
Follow the procedure below to check how many indoor or outside units are turned on.
NOTE:
Press the MODE button (BS1) if you get confused while operating.
This returns to
Setting Mode 1 (H1P : OFF, default).
10.2.6.2
Procedure of Adding Refrigerant Charging and Check Operation
Warning Electric Shock Warning
Make sure to close the Electrical Components Box lid before turning on the power.
Perform the setting on the PC-board (A1P) of the outside unit and check the LED display after
the power is on via the inspection door which is in the Electrical Components Box lid.
Use an insulated rod to operate the push buttons via the Electrical Components Box inspection
door.
(LED display:
h
...OFF
i
...ON
j
...Blinking
∗
...Uncertain)
LED display
H1P H2P H3P H4P H5P H6P H7P
(1) Press the MODE button (BS1) once at Setting Mode 1 (H1P : off),
and set the MONITOR MODE (H1P : Blinking).
j h h h h h h
(2) Press the SET button (BS2) the number of
times until the LED display matches that at
right.
For checking the
number of outside
units : eight times
j h h i h h h
For checking the
number of indoor
units : five times
j h h h i h i
(3) Press the RETURN button (BS3) and read the number of units from
the display of H2P through H7P.
[Reading Method]
The display of H2P through H7P should be read as a binary number,
with
j
standing for [1] and
h
standing for [0].
j
∗ ∗ ∗ ∗ ∗ ∗
j h j h j j h
(4) Press the MODE button (BS1) once. This returns to Setting Mode 1
(H1P : OFF, default).
h h i h h h h
Ex: For the LED display at right, this would be “0 1 0 1 1 0 ”,
which would mean 22 units are connected.
Note: “000000” indicates 64 units.
32 × 0 + 16 × 1 + 8 × 0 + 4 × 1 + 2 × 1 + 1 × 0 = 22 units
EL. COMPO. BOX Inspection door
Inspection door
EL. COMPO. BOX lid
Push button
(BS1~5)
Lift the protruding part to
open the inspection door
LED (H1~8P)
figure 29
EL. COMPO. BOX (1) (right)
Inspection door
EL.COMPO. BOX (2) (left)
Do not open the
EL. COMPO. BOX (2)
(left) lid or that inspection
door.
Inspection door
EL. COMPO. BOX (1) (right) lid
Push button
(BS1~5)
Lift the protruding part to
open the inspection door.
LED (H1~8P)
REYQ72~120PYDN
REYQ72~144PTJU
REMQ72~120PYDN
REMQ72~120PTJU