Pilot's Operating Handbook
Section 5
Performance
Edition 0 - March 05, 2019
Rev. 0
Page 5.8.1
5.8
- Engine operation
The following tables or/and the optimum torque indicator must be used during normal
operation of the airplane.
▲
CAUTION
▲
It is the responsibility of the operator to make sure that the required
version of GARMIN system software is installed prior to using the
hereafter engine operation tables.
The GARMIN system software required for this revision of the engine
operation tables is the version 0719.14 or later.
This information is displayed on the MFD power-up page upon system
start.
▲
▲
CAUTION
▲
The TRQ setting must never exceed 100 %.
When setting TRQ, Ng must never exceed 104 %.
▲
The following conditions are given for all the tables (pages 5.8.4 to 5.8.11) :
●
NOTE
●
Inertial separator must be OFF and BLEED HI msg OFF.
●
-
Landing gear and flaps UP.
-
BLEED switch on AUTO.
-
represent the ISA conditions at the flight level.
The torque must be set at or below the value corresponding to the local conditions of
flight level and temperature.
●
NOTE
●
The engine ITT limit at 840
°
C during continuous operation may be used in case
of operational need.
●
PIM - DO NOT USE FOR FLIGHT OPERATIONS