Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 3
Page 8.9.4
3)
Remove blanking plugs (31) located in line with R.H. front side window
- see figure 8.9.3 detail C, and install them on holes located in line with
card table - see figure 8.9.3 detail D.
●
NOTE
●
Should long term changes be made to cabin configuration (4 / 6 seats), cabin
upholstery blanking device and plug arrangements will need to be reconfigured
in order to optimize the temperature conditioning system.
Subject changes should preferably be performed at a recognized service
center.
●
G - Installation of intermediate seats - see figures 8.9.2, 8.9.3 and 8.9.4
1)
Install deflector (34), ensuring that both red marks (36) are aligned with
the deflector holes (35) - see figure 8.9.4.
●
NOTE
●
Position deflectors (34) as indicated on label, according to future position of
intermediate seat, in order to optimize cabin cooling.
●
2)
Install intermediate seats.
●
NOTE
●
If seats are installed facing flight direction (frontwards), the L.H. seat must be
installed on the right and the R.H. seat on the left in order to have the armrest
on aisle side.
●
a)
Pull backrest bottom upholstery (25) to remove it.
b)
Clear the carpet from seat area to facilitate moving in rails.
c)
Position the seat and put lock (22) near the color mark (37) made
on rail bottom on aisle side.
●
NOTE
●
The color mark (37) in the rail is aligned with red marks (36).
●
d)
Open the floor hatch and remove clip from holder located under
floor panel and connect heating system harness (26). Clip
connectors on the holder located on the seat structure.
e)
Pull up locking handle (21), insert pads (23) into rail (24)
apertures and then, move the seat so that lock (22) is in front of
the color mark (37).
PIM - DO NOT USE FOR FLIGHT OPERATIONS