Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 52 / 344

WHEEL BRAKE ASSEMBLIES Brake Cluster Removal and Installation
Page 6-6 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
6
Brake Shoe Installation, Continued:
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding. Make sure the shoes are
positioned vertically so the tips of the shoes are positioned flush with the top surface of the shoe
mounting blocks as shown (Figure 6-13, Page 6-6).
6. Install axle shaft (2) into axle tube and install retaining ring (1) (Figure 6-3, Page 6-2). See WARNING
on page 6-9.
7. Install the brake drum and make sure that it is properly seated. See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting slots.
8. After the drum is installed, make sure the axle and drum turn freely.
BRAKE CLUSTER REMOVAL AND INSTALLATION
Read WARNING on page 6-1.
REAR BRAKE CLUSTER REMOVAL
1. Place chocks at the front wheels, loosen the lug nuts on the rear wheels and lift the rear of the vehicle
with a chain hoist or floor jack. Position jack stands under the axle tubes and lower the vehicle to let the
jack stands support the vehicle. See Figure 9-2, Section 9, Page 9-3.
2. Release park brake and loosen equalizer retaining nuts on equalizer rod (3) to slightly loosen brake
cable (Figure 6-16, Page 6-9).
3. Remove the rear wheels and then the brake drums.
4. Remove the axle:
4.1. Using 90° snap ring pliers, remove the axle retaining ring (1) (Figure 6-3, Page 6-2).
4.2. Pull the axle shaft (2) from the axle tube (Figure 6-3, Page 6-2).
Figure 6-12 Insert Shoes Figure 6-13 Position Shoes
SLOT
SLOT
SLOTS
TIPS