Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 172 / 344

ELECTRICAL COMPONENTS Reverse Warning Buzzer
Page 12-20 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
12
REVERSE WARNING BUZZER
Read DANGER and WARNING on page 12-1.
Testing the Reverse Warning Buzzer
See Test Procedure 20, Section 11, Page 11-37.
Reverse Warning Buzzer Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Remove the center dash panel. See Key Switch Removal on page 12-15.
3. Disconnect the wires from the reverse warning buzzer (2). Do not allow wires to touch (Figure 12-21,
Page 12-20).
4. Remove the mounting screws (3) securing the buzzer to the center dash.
Reverse Warning Buzzer Installation
1. Install the screws (3) through the buzzer bracket tabs and tighten to 3.5 in-lb (0.40 N·m) (Figure 12-21,
Page 12-20).
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Reverse removal procedures to install the center dash in the vehicle. Be sure that the key switch termi-
nals cannot touch the frame and that the panel is properly seated and snapped in place.
5. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
Figure 12-21 Front Reverse Warning Buzzer
B
-M
A
+M
S
AS SEEN
FROM
FRONT
DRIVER SIDE
OF VEHICLE,
BODY
REMOVED
3
2