Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 285 / 344

UNITIZED TRANSAXLE Unitized Transaxle Removal
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 16-13
16
16. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle (Fig-
ure 16-29, Page 16-13).
17. Loosen, but do not remove, the governor arm retaining bolt. Remove the governor arm from the shaft
(Figure 16-30, Page 16-13).
18. Remove screws securing the governor cable bracket to transaxle (Figure 16-31, Page 16-13).
19. Remove screws securing the accelerator cable bracket to transaxle (Figure 16-32, Page 16-13). See
following NOTE.
NOTE: The governor cable and the accelerator cable should remain attached to the governor arm.
20. Remove the six bolts mounting the unitized transaxle to the engine.
20.1. Remove four transaxle mounting bolts (one at each corner of the transaxle mounting plate) as
shown (Figure 16-33, Page 16-14).
20.2. Remove two middle transaxle mounting nuts as shown (Figure 16-33, Page 16-14).
21. Remove leaf springs, stabilizer bar, wheels and brake assemblies from the transaxle.
Figure 16-29 Driven Clutch Figure 16-30 Governor Arm
Figure 16-31 Governor Cable Bracket Figure 16-32 Accelerator Cable Bracket
Remove bolt and
mounting washer
from driven clutch.
Leave cable
connected.
Loosen nut. Then, with governor
and accelerator cables still attached,
remove the governor arm from the shaft.
Leave cable
connected.
Remove two screws
holding governor
cable bracket.
Remove two
screws holding
accelerator
cable retaining
bracket.
BRACKET