Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 234 / 344

FE350 ENGINE Crankshaft Axial Play Adjustment
Page 13-46 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
13
Camshaft Installation, Continued:
3. Align the timing marks (3) (Figure 13-102, Page 13-46). See following NOTE.
NOTE: If the outside edges of the camshaft and crankshaft gears are not flush, and the crankcase cover will
not easily make full contact with the crankcase, make sure the tang on the oil pump rotor is seated in
the camshaft slot.
Camshaft Axial Play Adjustment
1. With the gasket (1) installed on the crankcase, measure from the gasket surface to the cam gear sur-
face (2). Record this measurement (Figure 13-103, Page 13-46).
2. Measure from the crankcase cover (3) mounting face to the camshaft bearing inner end (4).
3. Locate the measurements on the Camshaft Shim Table. Follow the lines to where the recorded mea-
surements intersect (Figure 13-105, Page 13-47).
4. Choose the next smaller shim from the table. EXAMPLE: Measurement A is 13.41 mm and B is 14.09
mm. The correct camshaft shim is 0.4 mm.
5. Install the shim (1) on the camshaft (2) (Figure 13-104, Page 13-46).
Figure 13-101 Proper Seating of Tang into
Camshaft Slot
Figure 13-102 Align Timing Marks between Camshaft
and Crankshaft
Figure 13-103 Measurements to be Recorded
for Camshaft Shim Table
Figure 13-104 Shim Installation on Camshaft
2
1
3
B
A
2
3
4
1 1 2