Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 30 / 344

BODY AND TRIM Rear Fender
Page 4-8 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
4
Tilt Bed Removal Continued:
2. Remove two locknuts (10) from left and right tilt bed hinge assemblies (3) (Figure 4-3, Page 4-7).
3. Apply slight upward pressure (by hand) on the rear of the bed to relieve pressure on the hinges and
remove the hinge bolts (9) from the hinge assemblies.
4. Raise rear edge of bed approximately 6 inches (15.2 cm) and pull bed assembly toward rear of vehicle
approximately 3 inches (7.6 cm) to release bed latch assembly (2) from latch plate (1) (Figure 4-3,
Page 4-7).
5. Lift bed from vehicle.
TILT BED INSTALLATION
1. Hold bed at a slight angle (front of bed lower than rear of bed) to vehicle and place front edge of bed
onto vehicle frame. Bed latches (5) should be engaged with latch plates (1) (Figure 4-3, Page 4-7).
2. Lower edge of bed onto vehicle and align hinge brackets (3) with bed hinge (25) (Figure 4-3,
Page 4-7).
3. Start the bolts (9) into left and right hinge assemblies (3 and 25). It may be necessary to use an align-
ment tool to align holes in hinge bracket with steel bushing in hinge assembly (Figure 4-3, Page 4-7).
4. Use a small hammer to lightly tap bolts through hinge assembly.
5. Install a nylon locknut (10) on each bolt (9) and tighten to 15 ft-lb (21 N·m) (Figure 4-3, Page 4-7).
6. Lift bed and place the prop rod (17) in bed mounting hole. Install a 3/8 inch flat washer (22) and a new
cotter pin (23) on prop rod (Figure 4-3, Page 4-7).
REAR FENDER
Read WARNING and CAUTION on page 4-1.
REAR FENDER REMOVAL
1. Remove two nylon locknuts (3) and flat washers (1) from front of fender. Remove two 1/4 x 1 bolts (2)
from front of fender (6) (Figure 4-6, Page 4-11).
2. Remove two nylon locknuts (3) and flat washers (1) from top of fender (6). Remove two 1/4 x 1 bolts (2)
and flat washers (1) from the top of fender (6) (Figure 4-6, Page 4-11).
3. Remove fender (6) from vehicle (Figure 4-6, Page 4-11).
REAR FENDER INSTALLATION
1. Unload the cargo bed.
2. Open the cargo bed and engage the prop rod.