Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 207 / 344

FE350 ENGINE Cylinder Head
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 13-19
13
PUSH ROD INSPECTION
1. Support the rod in V blocks at each end of the rod. Position a dial gauge perpendicular to the rod (Fig-
ure 13-35, Page 13-19).
2. Turn the rod slowly and read the variation on the gauge.
3. If the push rod is bent more than 0.019 inch (0.5 mm), replace the push rod.
CYLINDER HEAD INSTALLATION
Read DANGER and WARNING on page 13-1.
1. Installation is the reverse of removal. See Cylinder Head Removal on page 13-10.
2. Making sure that each push rod (5) is in place between the rocker arm (3) and the hydraulic lifter as
shown, put the rocker shaft (2) into the posts through the rocker arm (3) and washer (4) (Figure 13-36,
Page 13-20).
3. Slide the washer (4) against the exhaust rocker, and fit the E-ring (1) into the groove in the rocker shaft
(2) (Figure 13-36, Page 13-20).
4. Install cylinder head assembly to engine.
5. Tighten the bolts down evenly by hand.
6. Using a torque wrench, tighten the six bolts in the sequence shown (Figure 13-37, Page 13-20).
7. Increase the torque in four increments of 50 in-lb (6 N·m) and then tighten to final torque of 220 in-lb
(25 N·m). See following CAUTION.
∆ CAUTION
• Do not turn any one bolt down completely before tightening the others. Doing so may cause the
cylinder head to warp.
Figure 13-34 Measure Rocker Shaft I.D. Figure 13-35 Check For Push Rod Distortion
A
2
A
B
C
D D
C
B
A
2
1
2
1
2 1
2
1
A
1
Measure each position in
two places 90
°
apart.