Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 55 / 344

WHEEL BRAKE ASSEMBLIES Brake Cluster Removal and Installation
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 6-9
6
Rear Brake Cluster Removal, Continued:
5. Remove cotter pin (17) and clevis pin (16) from brake cable (Figure 6-14, Page 6-7).
6. Remove 4 bolts (20) and cone lock nuts (19) that mount the brake assembly to the transaxle (Figure 6-
14, Page 6-7).
7. Remove rear brake cluster assembly from transaxle.
REAR BRAKE CLUSTER INSTALLATION
1. Install in reverse order of disassembly. Use new cotter pins when installing brake cables.
∆ CAUTION
• Before installing axle shaft, clean any oil from axle shaft and oil seal areas.
2. Be sure bolts (20) and new cone lock nuts (19) are used to mount the brake assembly (Figure 6-14,
Page 6-7).
3. Tighten bolts to 30 ft-lb (40 N·m). See following WARNING.
∆ WARNING
• Be sure retaining ring is properly seated in groove. If ring is not properly installed, axle
assembly will separate from transaxle and damage axle assembly and other components.
Loss of vehicle control could result in severe personal injury or death.
4. Adjust brakes. See Brake Adjustment on page 6-16.
Figure 6-16 Front Brake Cable Routing
DETAIL A
DETAIL B
9
8
5
4
1
6
2
7
3