Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 51 / 344

WHEEL BRAKE ASSEMBLIES Brake Shoe Installation
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 6-5
6
BRAKE SHOE INSTALLATION
NOTE: Components of the front wheel brake assembly are identical to the rear wheel manually adjusted
brake assembly. The front brake assembly is rotated 90° (when compared to the rear brake assem-
bly) so the adjusting bolt on each assembly is oriented to the rear of the vehicle rather than at the top
of the assembly (Figure 6-15, Page 6-8).
1. Position one shoe in the slots in the mounting block anchor piston and brake actuator (Figure 6-10,
Page 6-5). See following WARNING.
∆ WARNING
• When installing brake shoes, the shoes must be oriented with tips stamped J10 inserted into
the mounting block anchor piston slots rather than into the brake actuator slots (Figure 6-10,
Page 6-5). Incorrectly installed brake shoes will be too tight and make adjustment of the brake
impossible.
2. Install shoe retainer clip (1), using pliers to compress clip while turning clip retainer pin (2) into position
(Figure 6-11, Page 6-5).
3. Attach the springs (with hooks pointing outwards) onto the shoe already installed. Then hold the other
shoe next to it, correctly oriented, and attach the springs to it (Figure 6-14, Page 6-7).
NOTE: With brake shoe tips marked J10 oriented to the mounting block, the stamping will be visible on one
shoe only. The other J10 stamping will be facing the backing plate and will not be visible.
4. While maintaining spring attachment on both shoes, position the tips of the second shoe into mounting
slots and then push shoe into place. Hold shoe in position and install the retaining clip and pin (Figure
6-12, Page 6-6).
Figure 6-10 Position Shoes Figure 6-11 Retainer Clip
J10
J10 STAMPING
ON SHOE
1
2