20
If no signal is received within 20
sec, SUPER 32-DT35A will emit a
long beep and automatically
returns to Programming mode.
Step 3:
SUPER 32-DT35A will emit 2
beeps to indicate the device is
learnt-in successfully.
Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
If
one long beep
is emitted
instead of 2 beeps, this indicates:
The device has already been
learnt-in.
When an 8
th
device is attempted
to learn-in.
Step 4:
Repeat Steps 1-3 until all devices
are learnt-in.
<NOTE>
Adding a device for a second time is
prohibited unless it is removed from
the system first.
Pressing the Button on Smoke
Detector will cause Smoke Detector to
send an event code (VRI code: 11)
which is the same as the one when the
Smoke Detector is triggered.
Command 95
Learn-In Sensor with Device ID
If sensor device ID is given (please refer to
label sticking on the device or consult the
supplier), you can learn the device into
SUPER 32-DT35A using device ID.
Step 1:
Depending the device type, enter
0903
for 93# (Silent Device) or
0904
for 94# (Non-silent Device
)
Enter
0903
for learning in silent
devices.
Enter
0904
for learning in smoke
detectors, CO detectors, pendants,
fixed emergency transmitters, or
long range pendants.
Step 2:
Enter
Device ID number
following
the the input rule below.
For single-digit number, enter “0”
followed by the number. Enter “01”
instead of “1”.
0-9=00-09, A=10, B=11, C=12,
D=13, E=14, F=15
Example:
Device Type
93
+ Device ID
F1E711A001
should be input as
090315011407010110000001
93 represents a silent device type,
and should be entered as 0903.
F1E711A001 represents the device
ID and should be entered as
15011407010110000001
Command 98
Factory Default Reset
To Reset SUPER 32-DT35A to factory
default settings, enter (
98
) and then (
#
).
After one short beep, continue by entering
(
) and then ending with another (
#
),
one beep will sound for termination.
Once the
Factory Default
Reset
is
executed, all the programmed data is
returned to its default value and all the
devices that have been learnt-in are
removed. You have to do the programming
and learn-in the device one by one again.
Command 99
Exit Programming Mode
Enter (
99
) and (
#
), after one short beep,
SUPER 32-DT35A exits the Programming
Mode and returns to idle mode.
Содержание SUPER 32-DT35A
Страница 1: ...Super 32 DT35A User Manual...
Страница 43: ...40...