9
phone set if Function Selection is
successful.
Command 01-06
Telephone Number Programming
Used to program the 1
st
-
6
th
Tel. numbers
respectively.
To program the 1
st
Tel. number: enter (
01
)
followed by (
#
). After one short beep, enter
(
telephone number)
followed by (
#
). The
1
st
Tel.
number
is
programmed
successfully.
Likewise, the 2
nd
, 3
rd
or 4
th
, 5
th
, or 6
th
Tel.
numbers can be programmed using
Command (
02
), (
03
),
(04)
,
(05)
or (
06
)
respectively.
<NOTE>
When entering the phone number,
entering (
) represent a 3-sec. pause.
(e.g. Switchboard system, extension, etc.)
Up to 20 digits including (
) are allowed
for each telephone number.
Delete Telephone Number
：
To delete the 1
st
Tel. number, enter (
01
)
followed by (
#
), after one short beep, enter
another (
#
). SUPER 32-DT35A will emit
another short beep, signaling the 1
st
Tel.
number is erased.
Likewise, you can erase the respective 2
nd
,
3
rd
, 4
th
, 5
th
or 6
th
Tel. Numbers, by following
the above procedure.
Command 08
Report Sequence
This command is used to select the report
sequence.
The options are: Alternate and One-by-
One
Alternate Report Sequence: The reporting
sequence will go through all reporting
destinations once before retrying the same
reporting destination. E.g.
1 > 2 > 3 > 1 > 2 > 3 > 1 > 2 > 3 > …
One-by-One Report Sequence: The
reporting sequence will go through the
same reporting destination for 4 times until
reporting to the next reporting destination
(for 4 times). E.g.
1 > 1 > 1 > 1 > 2 > 2 > 2 > 2 > 3 > …
Function
Selection
Result
(0)
Alternate
(1)
One-by-One
Factory default is (
0
),
Alternate
.
Command 10-16
Account Number Programming
Commands (
10-16
) are used to set the
account number for the telephone numbers
used for Digital Reporting.
Command (
10
)
：
Set the
same
account
number for
all
telephone numbers.
Command (
11-16
)
：
Set the account
numbers for the 1
st
-
6
th
Tel. numbers used
for Digital Reporting
respectively.
In (
Function Selection
) key in an
Account
Number
of 4-12 digits.
Command 18
Report Format (when to stop reporting)
When this function is set as (
0
): If both
digital reporting and speech reporting are
programmed, the sequence of reporting
will be terminated after one successful
digital reporting (in CID, Scancom,
Tunstall or Franklin 4 + 2 format) and one
successful speech reporting.
If only digital reporting is programmed or
only speech reporting is programmed, the
sequence of reporting will be terminated
automatically after one reporting is
answered successfully.
When this function is set as (
1
): The
sequence of reporting will be terminated
automatically after one reporting has been
answered successfully.
When this function is set as (
2
): The
sequence of reporting will be terminated
when all programmed reportings (digital,
speech,
or
both)
are
answered
Содержание SUPER 32-DT35A
Страница 1: ...Super 32 DT35A User Manual...
Страница 43: ...40...