Climax SUPER 32-DT35A, Руководство пользователя, Страница: 22 / 62

19
(0) Enable , SUPER 32-DT35A will send a
No Pendant Learnt-in report to the
Monitoring Center when no pendent is
learnt into the Panel 30 mins after powering
up. SUPER 32-DT35A will repeat every
hour thereafter, until a pendant is
successfully learnt in.

If No Pendant Learned-in Report is set to
(0) Disable , SUPER 32-DT35A will Not
send a No Pendant Learnt-in report to the
Monitoring Center
Function
Selection
Result
(0)
OFF
(Disable)
(1)
ON
(Enable)

Factory Default is (1), Enable .
Command 80-82
Remove Devices

The SUPER 32-DT35A can be
programmed to remove ALL previously
learnt-in devices by entering ( 80) followed
by (
＃
). The system will sound an
acknowledge beep over the phone for the
user.

Command ( 81 ) is used to remove Zone 1
Device .

Command ( 82 ) is used to remove Zone 2
Device .
Commands 93
Learn-In Silent Device

For learning Silent Device :
Step 1: Enter 93 + # on the phone set, then
a short beep will be heart via the
phone set. (If no command is
dialed, SUPER 32-DT35A will exit
Programming mode automatically
and return to idle mode).
Step 2: Press the Device Button within 20
secs.

Learning can only be completed
within the signal reception range of
SUPER 32-DT35A.

If no signal is received within 20
sec, SUPER 32-DT35A will emit a
long beep and automatically
returns to Programming mode.
Step 3: SUPER 32-DT35A will emit 2
beeps to indicate the Silent Device
is learnt-in successfully.

Adding a Device for a second time
is prohibited unless it is removed
from the system first.

If one long beep is emitted
instead of 2 beeps, this indicates:
 The device has already been
learnt-in.
 Another device has been learnt-
in before.
<NOTE>

When SUPER 32-DT35A receives the
alarm signal from the Silent Device, it will
not sound any warning beeps during
Reporting and Guard time period.
Commands 94
Learn-In Non-silent Device

The available devices that can be learnt-in
via Command #93 and #94 are:
 PIR Sensor ----- PIR

Smoke Detector ---- SD
 Carbon Monoxide ---- CO
 Temperature Sensor ---- TS
 Fixed Panic Button ---- PB
 Wrist Transmitter ---- WTR
 Pendant Transmitter ---- WTR
 Water Sensor ---- WS
 Fall Sensor ---- FS
 Medication Dispenser
Step 1: Enter 94 + # on the phone set, then
a short beep will be heard via the
phone set. (If no command is
dialed, SUPER 32-DT35A will exit
Programming mode automatically
and return to idle mode).
Step 2: Press the learn button on the
device within 20 secs.

Learning can only be completed
within the signal reception range of
SUPER 32-DT35A.