Climax SUPER 32-DT35A, Руководство пользователя, Страница: 16 / 62

13

When this function is programmed as ( 1 ),
after a successful reporting to the
Monitoring Center, SUPER 32-DT35A will
automatically hang up the line and start a
5-minute waiting period to auto answer any
incoming phone calls from the Monitoring
Center.

When this function is programmed as ( 2 ),
after a successful reporting to the
Monitoring Center, the SUPER 32-DT35A
will automatically enter specific Follow-On
mode as specified by Command (
45 ).
Once Follow-On Mode is terminated,
SUPER 32-DT35A will automatically start a
5-minute waiting period to auto answer any
incoming phone calls from the Monitoring
Center.
<NOTE>

When the Monitoring Center calls back
within this 5-minute period, SUPER 32-
DT35A auto-answers the call after the
1st
-
2nd ring and waits for proper Access
Code (default is ( 8744 )) entry followed by
the ( # ) key within 15 secs.
Upon the correct Access Code received,
SUPER 32-DT35A will then open a Full-
Duplex Communication to allow the Call
Recipient to speak to SUPER 32-DT35A
directly.
You can use DTMF command to switch
the communicating method. Please refer
to section 4.2. Alarm Activation.

The first digit of Access Code must be
entered within 15 secs, otherwise, SUPER
32-DT35A will disconnect the call
automatically.

Failure to enter the correct Access Code
within 2 mins will cause SUPER 32-
DT35A to automatically disconnect the
call.

To terminate the call, press DTMF ( 9 ) or
RESET BUTTON on SUPER 32-DT35A.

If the 5-minute waiting period is up,
SUPER 32-DT35A will automatically exit
this waiting mode and return to idle mode.

Command #41 (Auto Answer for Remote
Programming) will not be able to proceed
during the 5-mins Call-back time.
Command 39
Dialing Mode

This function is for you to select the dialing
method of your telecommunications.

There are two dialing methods available for
user:
0 TONE
1 PULSE

TONE is set as Factory Default.
Command 40
Set Access Code

The Access Code is used to enter
Programming Menu (locally or remotely),
and the Call-Back Function.

It consists of 4 digits and has been set to
(
8744
) as factory default. Before you set
your own Access Code, (
8744
) must be
keyed in.

To set a new Access code; enter the
desired ( 4-digit number ) in Function
Selection .
Command 41
Auto Answer for Remote Programming

SUPER 32-DT35A can be programmed to
auto answer incoming phone calls after a
pre-set number of rings have been
reached. The number of rings ranges from
(
00 ) (no auto answer) to ( 32 ) rings.
Function Selection Result
(00) OFF
(01) - (32) ON

Factory Default is ( 20 ) Rings.
<NOTE>

If 00 is selected, it means the SUPER 32-
DT35A cannot auto-answer the call by
ring count. If you want to do Remote
programming, please follow the Remote
Programming method described under
System Conifuration, I. Entering
Programming Mode: 2. Remote
Programming Mode.