Climax SUPER 32-DT35A, Руководство пользователя, Страница: 10 / 62

7
5.2.2. Dial in Twice (Ring Count Disable)
If 00 is set in Command 41, it means SUPER
32-DT35A is disabled to auto answer the
incoming calls by ring count. If Remote
programming is required, you will need to call
SUPER 32-DT35A twice.
Step 1. Dial SUPER 32-DT35A and hang up
after first 2 rings, wait for another 8-20
sec then call again. SUPER 32-DT35A
will answer the call on the first ring.
You
will enter the Remote
Programming Mode after the first ring
from the 2
nd
call.
Step 2. Enter 8744 (the default 4-digit Access
Code) followed by # , via the phone
set.
Step 3. SUPER 32-DT35A will respond with
two quick beeps to indicate it is ready
for Remote Programming Commands.
Step 4. You are now in Programming Mode .
Proceed to program by referring to the
Command
in section 5.3
Programming SUPER 32-DT35A .
<NOTE>

The first digit of Access Code must be
entered within 15 seconds, otherwise the
SUPER 32-DT35A will exit automatically.

Failure to enter the correct Access Code
within 2 minutes will cause SUPER 32-
DT35A to exit the Programming mode
automatically.

To exit Remote Programming mode, enter
99 followed by # .
5.3. Programming Your
SUPER 32-DT35A
To program your SUPER 32-DT35A, you can
enter DTMF programming commands under
Local Programming Mode or Remote
Programming Mode.
Another programming option is to use the
programming software
Super Tool to program
your SUPER 32-DT35A from your computer.
Please refer to the
Super Tool User Guide for
details.
 How to enter Commands?
Please make sure SUPER 32-DT35A is in
Programming Mode before trying any
SUPER 32-DT35A Command Functions.
Please
refer to section System
Configuration, Entering Programming
Mode .
 Follow the protocol below to command
the SUPER 32-DT35A:
CC # DTMF
ACK
Function
Selection
# DTMF
ACK
1. 2. 3. 4. 5. 6.
1.
CC = 2-digit DTMF Command
2.
# = Termination of the DTMF Command
3.
ACK = DTMF Command
Acknowledgement from SUPER 32-
DT35A
Short beep: Command succeeded
Long beep: Command failed
4.
Function Selection = According to
different Command you will have different
entering in this part, e.g. Tel. Number,
Account number, etc.
5.
# = Terminates Function Selection
6.
ACK = Function Selection
Acknowledgement from SUPER
32-DT35A
Short beep: Function Selection succeeded
Long beep: Function Selection failed
 Follow the Command Steps to program
your SUPER 32-DT35A:
Step 1. Enter Command number (DTMF
Numeric Command, e.g. (
01 ), ( 02 )…)
Step 2. Press ( # ) to terminate the DTMF
Command.
Step 3. One short beep will be heard for
successful Command entry.
Step 4. Enter the desired Command function
number.
Step 5. Enter ( # ) to terminate the Command
Operation.
Step 6. SUPER 32-DT35A will emit a short